Electrophoretic frame accessories , solar panel and led lamp accessory
|Product||Electrophoretic frame accessories , solar panel and led lamp accessory|
|Material||Alloy 6060, 6061, 6063, etc.|
|Color||Different colors available (black, blue, green, champagne, bronze, golden, vermillion, etc.)|
|Surface treatment||Mill finish, anodized, electrophoretic coating, powder coating, thermal break, wood grain/wood-in-shift, etc.|
|Mould||Based on your drawing or use our mould free|
|Sample time||Usual practice: within 15 working days against payment|
|Usages||Windows, doors, curtain wall, solar panel, LED panel, heat sink, industry, etc.|
|Certified||ISO9001-2008 Quality System,|
The problems of aluminum alloy doors and Windows and the problem that should be paid attention
Special attention should be paid to the installation of coastal areas
Coastal areas due to the amount of salt content in the wind and rain is large, to use national standard parts is strictly prohibited without the fade of the processed the sand of the qing dynasty, the corrosion problem of aluminum alloy doors and Windows is more serious, should pay special attention. In addition to the above procedure, the following procedures should be strictly followed:
1: The aluminum doors and Windows should be placed in a well-ventilated, dry and clean warehouse.
2: Place the sleeper surface height should be > = 100 mm from the ground, pile shall not exceed 15 die per yard (fan), every module (fan) between the application of soft cushion flat material, in order to prevent the crushed and aluminium alloy, hardware mutual friction between the protective film on the surface of the material.
3: There must be a drip line at the door and door, and should be inspected before installation. Because the water of the wall that flows through the sand is very corrosive, must be guarded.
4: The installation of the iron plate should be used in the card type, and minimize the amount of processing to destroy the aluminum alloy protection layer.
5: Use the neutral glue to seal the aluminum alloy section to prevent rainwater from entering into the inner cavity without protective layer. According to experience, corrosion usually begins with an inner cavity without a protective coating.
6: The inside and outside is finished. Tear to protect the tape and clean doors and Windows, must not use the corrosive ratio of liquid and hard materials to clean doors and Windows, in order to avoid damaging the surface paint film.
7: Important tips:
(1): aluminum is a reactive metal. The damage of the protective layer is not anti-corrosion. It is easy for the flat group to adopt the necessary to strengthen the protection of the paint film on the profile.
(2): Water is the source of corrosion and should prevent the rain from entering the cavity of aluminum alloy section without corrosion resistance.
Contact Us at Any Time